Custom Pants Measurement Guide

To ensure your custom pants fit correctly and the impact protectors are positioned effectively, please provide measurements from a pair of pants that currently fit you well.

Requirements:

1. A pair of well-fitting non-stretch pants.

2. A measuring tape.

3. A flat surface.

Critical Step: Marking the Knee

We need to know exactly where your knee lands to position the impact protectors.

1. Put the pants on and sit in your normal riding position (chair or motorcycle).

2. Mark the centre of your kneecap on the fabric with chalk or tape.

3. Remove the pants and lay them flat to measure.

---

 

Measurements

Please record all values in cm with the fabric smoothed flat.

1. Waist Width: Button the pants and pull the waistband tight so the front and back align. Measure straight across the top edge.

2. Front Rise: Measure from the crotch seam "cross" (where the four seams meet) up to the top of the waistband. 

3. Back Rise: Measure from the crotch seam "cross" up to the top of the back waistband.

4. Outseam Length: Measure from the top of the waistband (side) down to the bottom hem.

5. Inseam Length: Measure from the crotch seam "cross" down the inside leg to the bottom hem.

6. Knee Height: Measure from the crotch seam "cross" down the inside leg to the height of your centre-knee mark.

7. Knee Width: Measure the width of the pant leg straight across at the exact height of your centre-knee mark.

8. Bottom Hem: Measure straight across the bottom leg opening. if elasticated, measure when fully stretched and when also when relaxed

Please send your measurements to info@wh05dat.com